Warranty Card - Ferm BCM1020 Traducción Del Manual Original

• Unplug the power cord (9) before replacing the
fuse.
• Remove the fuse (4) cover by slightly pressing
in the side.
• Unscrew the fuse (4) with a fitting open-end
spanner and secure the new fuse.
• Then screw it tight and replace the cover (4).
Note: If you need a new fuse, please contact our
service department (see chapter warranty and
service information)
Defective batteries
• Damaged batteries which do not retain their
charge.
It is often the case that batteries which are in
very bad condition can no longer be charged;
they need to be replaced because they do not
retain their charge.
• Short circuited batteries.
If, after several hours the battery charger still
does not indicate that the battery is being
charged, this usually means that one of the
elements is short circuited. The battery needs
to be replaced.
Malfunction
If your battery charger no longer functions as it
should, this may be due to the following reasons:
• The clamp has been connected wrongly.
Check if the right clamp is connected to the
right terminal.
• The safety switch is switched off.
Battery life
The life of your battery will be considerably longer
if the following advice is taken:
• Check the liquid level of the battery every
month and, if necessary, fill it up with distilled
water.
• Clean the terminals of your battery regularly to
prevent deposit. Put a little bit of vaseline on
the terminals.
• If the vehicle is seldom used, the battery will
discharge. Therefore it needs to be charged
regularly to maximum capacity. In this way
malfunctioning can be prevented.
If everything has been checked, and the battery
charger still does not charge as it should, it
needs to be taken to the Service address on the

warranty card.

8
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
For the conditions of warranty, please refer to the
separately provided warranty card.