Cleaning, Maintenance And Ordering Spare Parts; Ordering Replacement Parts; Using For The Fi Rst Time; Disposal And Recycling - EINHELL AQUINNA Manual De Instrucciones Original

5.5 Battery capacity indicator (Fig. 4)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs fl ash:
The battery pack has undergone exhaustive
discharge and is defective. Do not use or charge
a defective battery pack.
6. Operation
6.1 On/Off /Pump setting switch (Fig. 1/Item 5)
Switch position 0: Off
Switch position I: Pump setting 1
Switch position II: Pump setting 2
Important!
Selecting pump setting 2 increases the maximum
delivery pressure, but it reduces the maximum
operating time of the battery as a result.
6.2 Using for the fi rst time
•
Install the equipment on a solid and level
surface.
•
Fill the pump housing with water via the
water filler screw (3). Filling the intake line will
accelerate the priming process.
•
All the shut-off devices in the discharge
line (spray nozzle, valves etc.) must be fully
opened during intake in order to permit all air
to escape from the intake line.
•
The intake process starts automatically after
you have pressed the On/Off/Pump setting
switch (5). Water can be suctioned in for up to
5 minutes (maximum suction height).
•
If the pump is removed after use, it is
essential that it is filled with water again the
next time it is connected and started.
Switch the pump off again after use by pressing
the On/Off /Pump setting switch (5) again and
allow the pump to cool down.
GB
7. Cleaning, maintenance and
The equipment almost completely maintenance
free. In order to ensure a long service life,
however, we recommend regular checks and
product care.
Danger!
Always remove the batteries before starting any
cleaning work.
7.1 Maintenance
•
•

7.2 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
•
•
•
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 21 -
www.sidirika-nikolaidi.gr
ordering spare parts
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
There are no other parts inside the equipment
which require maintenance.
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required