Festo CPX−2A Serie Manual De Instrucciones página 17

1 User
The CPX analogue I/O modules are intended for use only in
CPX terminals. The analogue I/O modules for CPX ter
minals each consist of an electronic module which is fitted
together with a combinable sub−base in a manifold base of
the CPX terminal.
The maximum values specified in the section "Technical
specifications" must be observed during operation. De
tailed information can be found in the manual for the CPX
analogue I/O modules as well as in the CPX system manual
P.BE−CPX−SYS−... .
Warning
S Before carrying out installation and maintenance
work, switch off the following:
S Connect an earthing cable with sufficient
cross−sectional area to the connection on the CPX
terminal marked with the earth symbol.
S The I/O modules contain electrostatically sensitive
components. Do not therefore touch any contacts.
Observe the regulations for handling electrostatically
sensitive components.
Please note
Commission only a CPX terminal which has been fitted
and wired completely.
Festo CPX−AX 0503a English
instructionsEnglish
the compressed air supply,
the operating and load voltage supplies.
17