Festo CPX−2A Serie Manual De Instrucciones página 21

Fit the analogue I/O module:
1. Only if the electronic module has been removed: Press
the electronic module carefully into the manifold base.
2. Check the seal and sealing surfaces and refit the sub−
base.
3. Place the screws so that the self−cutting threads are
used. Tighten the screws by hand in diagonally oppo
site sequence. Tightening torque 0.9...1.1 Nm.
3.3 Setting the DIL switches
With the switch elements of the 2−element DIL switches
you can set the following:
with modules 2AE−U−I, 4AE−I and 2AA−U−I: the signal
range
with temperature module 4AE−T: the number of inputs.
The following table shows the setting for DIL switch 0. It
applies correspondingly for DIL switch 1.
Festo CPX−AX 0503a English 21