Removal And Installation Of The Blade - Skil MS6305-00 Manual Del Propietário

Sierra ingletadora deslizante de 10 pulgadas de 15 a
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removal and installation of the blade

WARNING
equal or higher than the speed marked on the tool.
WARNING
WARNING
WARNING
will come in contact with the blade guards and/or chip deflector, while smaller blades will
defeat the function of the chip deflector which could result in blade guard damage which could
put user at risk.
NOTICE: Clean the blade of any excess oil before installation.
To remove the blade:
1. Position the head assembly in the up position and at 0° bevel. Tighten the slide-rail lock
knob so that the head assembly is secured in place. (See "ADJUSTMENTS" & Fig.6)
Fig. 6
2.
Rotate the lower guard by hand. Loosen, but do not remove the blade-bolt-cover screw
with the Phillips end of the
3. Rotate the blade-bolt cover counterclockwise so that the blade bolt is exposed (Fig.8).
4. Press and hold the spindle-lock button. Use the hex-end of the Double-Ended Allen
Wrench to remove the blade bolt by turning the wrench clockwise (Fig.8).
NOTICE: The blade bolt has left-hand threads.
Fig. 8
20
Only use wood-cutting blades that have a saw-blade diameter in
accordance with the markings on the saw and are marked with a speed
Use only blades with 5/8 in. arbor and blade kerfs less than or equal to
1/8 in . (3 .2 mm) .
To reduce risk of injury, use saw blade rated 4800/min (RPM) or greater .
Use of blades larger or smaller than indicated in the miter saw markings
could result in blade-guard and chip-deflector damage.
Double-Ended
1
3
Blade bolt
Fig. 7
Allen Wrench (Fig.7).
Blade bolt
cover
Larger blades
Blade bolt
cover screw
2
Spindle lock
button

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido