English; Safety Instructions - Krups SPEEDY PRO Manual De Instrucciones

English

Description
A Motor unit
B Bowl
C Blade
D Seal
E Lid
F Emulsifying disc (according to model)

Safety instructions

• This appliance complies with
applicable technical rules and
standards at the time of
manufacture.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
• It is designed to run only on
alternating current. Please check
before first use that the mains power
supply corresponds to that indicated
on the appliance's rating plate.
• Do not place or use this appliance on
a hot plate or close to a flame (gas
cooker).
• Only use the appliance on a flat,
stable, heat-resistant work surface
away from water splashes and any
sources of heat. Do not turn it upside
down.
• Disconnect the appliance:
- if it is not working correctly,
- before cleaning or maintenance,
- after use.
• Never pull the power cord to
disconnect the appliance.
• Only use an extension cord if you
have already checked that it is in
good working order.
• You must not use this household
electrical appliance if:
- it has been dropped,
- the blade is damaged or incomplete.
• If the power supply cord is damaged,
it must be replaced by our authorised
service dealer to avoid any risk of
danger.
• Do not let the power cord hang
down.
• Do not immerse the motor unit or
put it under water.
• Never pour or mix liquids or food
whose temperature is higher than
80°C (175°F) into the bowl. At this
temperature, liquid will not boil but
will release a small but visible
quantity of steam.
• Do not mix hot liquids.
• When mixing food which is warm, do
not fill the bowl above the 400 ml
mark.
• This product has been designed for
domestic use only. Any commercial
use, inappropriate use or failure to
comply with the instructions, the
manufacturer accepts no
responsibility and the guarantee will
not apply.
Use
Place the bowl (B) on the motor unit
(A) and lock it by turning it anti-
clockwise (Fig. 1)
First remove the plastic cover and then
fit the blade (C) or emulsifying disc (F).
Caution, the blades are extremely
sharp.
• To assemble the emulsifying disc: the
emulsifying disc is supplied in two
parts (axis + disc). Before using this
accessory, fit the axis onto the disc.
(Fig. 2). After this operation, the
accessory can no longer be
disassembled.
• Add the ingredients (Fig. 3).
• Do not go over the "max." level
shown on the bowl (400ml).
• Fit the lid (E) equipped with the seal
(D) and lock it by turning it anti-
clockwise (Fig. 4).
5