Establishing An Electrical Connection En; Version 230 Ven; Version 380V En; Automatic Starting En - Abicor Binzel xFUME VAC PRO Instrucciones De Servicio

xFUME VAC PRO
6.4 Establishing an electrical connection
WARNING
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Before establishing an electrical connection between the product and the mains, check whether the operating voltage
indicated on the nameplate corresponds to the mains voltage.
For the mains voltage and the fuse protection, please refer to:
 3.1 Technical data on page EN-7
 3.2 Nameplate on page EN-8
 13 Appendix
6.4.1 Version 230 V
The mains plug is not pre-attached.
1 Attach and plug in an appropriate mains plug (customer-specific).
6.5 Version 380V
The mains plug is not pre-attached.
1 Attach and plug in an appropriate mains plug (customer-specific).
6.6 Automatic starting
The automatic starting function enables the extraction system to be switched on automatically when the welding process
starts. When the welding process starts, the extraction system receives a signal from the robot control unit and automatically
starts the extraction process.
NOTICE
• The automatic function increases the extraction system's service life.

7 Operation

WARNING
Health risk due to harmful dust
Before and during operation, please observe the following:
• During operation, the complete extraction system must be kept closed.
• After switching off the extraction system, wait at least one minute before opening the dust collecting drawer.
CAUTION
Risk of injury
Injuries may be caused by improper handling.
• Do not draw in any flammable substances or liquids.
• Ensure sufficient ventilation while operating the extraction system.
 6.1 Transport and installation on page EN-11
BAL.0732.0 • 2019-09-18
7 Operation
EN - 13