3
Operation of the Appliance
3.5 Replacement of Lamp
(Figure 3)
Make the electrical connections of the appli-
ance. Your appliance uses 3W spot LED lamp.
For replacing the lamps, push downwards
on the holder from its behind, turn it coun-
ter-clockwise, and take it out downwards.
Apply the above operation in reverse to install
new lamps (Figure 3).
Bulb
Bulb Power (W)
Holder / Socket
Bulb Voltage (V)
Size (mm)
ILCOS Code
10 / EN
3
GZ 10
220 - 240
53 x 50
DR/F3-220-240-
GZ10-50-53
3.6 Operation with Chimney
Connection
Vapour is extracted through
•
the Chimney duct, which is fas-
tened to the connection head
on the hood.
The diameter of the Chimney duct must be
•
the same as the connection ring. In hori-
zontal settings, the pipe has to have a slight
upward slope (around 10º) so that the air
can exit the room easily.
3.7 Operation without Chimney
Connection
Air is filtered through the
•
carbon filter and recirculated in
the room. Carbon filter is used
when it is impossible to use a
Chimney in the house.
In Chimney less use, remove the flaps inside
•
the Chimney adapter.
Remove the Aluminum Grease Filter. To in-
•
stall the carbon filter, fit the filter to the tabs
by centring it on the plastic piece on both
sides of the fan body. Tighten it by turning
right or left.
Replace Aluminum Grease Filter.
•
Cooker Hood / User Manual