Connecting Your Peripherals; Connecting Your External Displays - Toshiba dynadock U3.0 Guía De Usuario

Setting Up the dynadock™ and Connecting Peripherals
NOTE

Connecting your peripherals

Once you have set up a USB cable connection between your
computer and the dynadock™, you can then connect your computer
peripherals to the appropriate ports on the dynadock™.

Connecting your external displays

The dynadock™ provides DVI and HDMI
can connect a digital (DVI) or analog (VGA) display via the DVI-I
video port and an HDMI
dynadock™. Two displays can be connected to the dynadock™ at
the same time.
NOTE
Connecting to the DVI-I video port
To connect a display to the DVI-I video port on the dynadock™:
1
If you are connecting a VGA display, attach the DVI-I to VGA
adaptor (included with the dynadock™) to the DVI-I video
port on the dynadock™.
2 Connect the display cable (not included) to the DVI-I video
port on the dynadock™ or to the adaptor you connected in
step 1.
3
Connect the other end of the cable to the external display.
NOTE
Connecting to the HDMI
To connect a display to the HDMI
1 Plug one end of the HDMI
HDMI
To disconnect the dynadock™ from your computer, directly unplug
the cable from the computer. The computer is now undocked.
If a USB storage device is connected to the dynadock™, make sure
you save the data located on the USB device, and then remove the
USB device first before undocking.
The dynadock™ U3.0 (
connecting an external display to the dynadock™.
The dynadock™ may not support VGA displays using Extended
Display Identification Data (EDID).
®
®
in port on the HDMI
®
display to the HDMI
) icon appears in the system tray after
out port
®
out port on the dynadock™:
®
cable (not included) into the
®
display.
®
dual output ports. You
®
out port on the
21