Additional Functions - SICK WLA16 Instrucciones De Operación

Ocultar thumbs Ver también para WLA16:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
6

Additional functions

8020348.14CS | SICK
Subject to change without notice
Alarm
Alarm output: The sensor (WLA16) features a pre-failure notification output ("Alarm" in
connection diagram
table
operation to a limited extent. The LED indicator flashes in this case. Possible causes:
Sensor or reflector is contaminated, sensor is out of alignment. In the good state: LOW
(0), if excessively contaminated HIGH (1).
Health
Health output: The sensor (WLA16) features a pre-failure notification output ("Health"
in connection diagram
[see table
ready for operation to a limited extent or the cable has been interrupted. Possible
causes: Sensor or reflector is contaminated, sensor is out of alignment, cable is dam‐
aged. In the good state: HIGH (1), if excessively contaminated or in the event of cable
interruption LOW (0). The yellow LED indicator flashes in this case.
Table 5: Alarm / Health
Test input
Test input: The WLA16 sensors feature a test input ("TI" or "Test" on the connection
diagram
[see table
2,
table 3
and, therefore, check that the sensor is functioning correctly: If female cable connec‐
tors with LED indicators are used, you have to ensure that the TI is assigned accord‐
ingly.
It is important that there is no object between the sensor and reflector; activate the test
input (see the connection diagram
shut down or the detection of an object is simulated. Refer to
tion. If the switching output fails to behave in accordance with
cation conditions. See section Fault diagnosis.
Table 6: Test
5), which issues a notification if the sensor is only ready for
5]), which issues a notification if the sensor is only
Alarm (≤ 100 mA)
+ (L+)
Alarm
‒ (M)
+ (L+)
Alarm
‒ (M)
and
table
6]), which can be used to switch the sender off
[see table
2,
table 3
Test → M
+ (L+)
Test
– (M)
ADDITIONAL FUNCTIONS
Health (≤100 mA)
+ (L+)
Health
‒ (M)
+ (L+)
Health
‒ (M)
and
table
6]). The send LED is
table 6
to check the func‐
table
6, check the appli‐
Test → L+
+ (L+)
Test
– (M)
6
7

Publicidad

Tabla de contenido
loading

Tabla de contenido