I Setting Of Pc Input - Panasonic WV-LC1700/G Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

I Setting of PC Input

While the PC input signal is being selected, you can adjust
the horizontal position and vertical position.
Note: Since this unit detects input signals and makes auto-
matic adjustments as required, this setting is not
required in ordinary cases.
1. Press the MENU button. The top menu will be displayed.
V I D E O A D J U S T
2. Move the cursor to PC SETUP by pressing the C or D
button. Press the MENU button. The PC SETUP menu
will be displayed.
Present input signals are displayed in the menu title.
For PC input terminal: PC IN
4. Move the cursor to the following setting items by pressing the C or D button. Then, adjust the levels by pressing the + or –
button.
Setting item
H-POSITION
V-POSITION
CLOCK
PHASE
5. Select EXIT, and press the MENU button. The top menu will be displayed.
6. Select EXIT on the top menu, and press the MENU button. The monitor display return to the default status.
Note:
• If no operation has been performed for 10 seconds or more, the monitor display returns to the default status.
• Check if the VGA output setting has been performed for the connected PC. (Refer to p. 9.)
• This monitor does not support plug-and-play. Depending on the connected PC, the PC SETUP menu can be controlled from
the PC keyboard. However, proper adjustment is not supported.
18
P C S E T U P
L A N G U A G E
E X I T
Effect
+: Screen moves to the right.
–: Screen moves to the left.
+: Screen moves upwards.
–: Screen moves downwards.
+: Clock is enlarged.
–: Clock is contracted.
+: Phase is increased.
–: Phase is decreased.
PC IN
1280 x 1024@60 Hz
H-POSITION
V-POSITION
CLOCK
PHASE
AUTO
EXIT
According to the timing data table ( page 9), present
signals are displayed at the right side of the menu title in
the format of [Resolution@Refresh rate (Vertical frequen-
cy)].
3. Move the cursor to AUTO by pressing the C or D but-
ton. Press the MENU button. The image display position
will be adjusted automatically.
Note:
• The screen flickers during automatic adjustments. This
is, however, not a malfunction.
• According to the situation of video signals, it takes sev-
eral seconds to 10-odd seconds to complete automatic
adjustments.
If an optimal screen cannot be obtained after automatic
adjustments, further operation specified below may be
needed.
Setting value
–40 to +40
–20 to +20
–20 to +20
0 to +63
00
00
+01
+38

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Wv-lc1900/g

Tabla de contenido