Power-On - Panasonic WV-LC1700/G Instrucciones De Operación

Power-On

Before operation, check the connections between monitors
and external devices (cameras, digital disk recorders, etc.)
(Refer to p. 12)
1. Press the power button. The monitor will be powered on,
and the power indicator will light up in green.
2. Press the INPUT SELECT button.
Every pressing this button can change input signals as
follows.
VIDEO A
PC
The signal name will be displayed on the upper right
corner of screen for 3 seconds.
Signal name
VIDEO A
VIDEO B
S-VIDEO
PC
14
VIDEO B/
S-VIDEO
Input signal type
Composite video A
Composite video B
S-video
PC (Analog RGB)
Note:
• When no input signal is supplied to the monitor, "NO
SIGNAL" will be displayed on the screen.
"NO SIGNAL" will continue to be displayed until an input
signal is supplied.
• When the loss of input signal is detected due to cable
disconnection, etc., "VIDEO LOSS" will be displayed on
the screen.
"VIDEO LOSS" will continue to be displayed until a cable
is connected.
• When the PC input signal is selected and picture display
position is not proper, perform the output setting of the
connected PC. (Refer to the diagram in p. 9.)