Major Operating Instructions And Their Functions; I Front View; I Rear View - Panasonic WV-LC1700/G Instrucciones De Operación

Major Operating Controls and Their Functions

I Front View

INPUT
SELECT MENU SELECT AUDIO
w r y
q e t u
q Power button
Powers on or off the monitor.
Note: Power is supplied from the connected cable even
while the monitor is OFF.
w Power indicator
This indicator lights green while power is supplied to the
monitor. Even though the monitor power is turned off, it
lights in red while the power supply is available.
e Input signal selection button (INPUT SELECT)
Every pressing this button can change input signals as
follows.
VIDEO A
PC
r Menu button (MENU)
• Displays the VIDEO ADJUST menu.
• Determines the selected parameter in setup menus.
t Selection buttons (SELECT: C, D)
These buttons move the cursor in setup menus.
y Audio buttons (AUDIO: +, –)
These buttons adjust the audio volume level. These but-
tons increments or decrements the selected parameter
in setup menus.
8
Video Monitor WV-LC1900
i o !0
VIDEO B/
S-VIDEO

I Rear View

!3 !5
!1 !2 !4
u Reset switch
Provideds restart this unit as necessary.
i Monitor stand
o LCD panel
Note: Take care not to pinch your hands or fingers
between the LCD panel and the monitor stand.
!0 Speaker
!1 Power cord clamp
After the power cord has been connected, remove the
screw that is used to mount the power cord clamp and
fasten the power cord.
!2 Power input jack (AC IN)
Connect the power cord (accessory).
!3 PC input connector (PC IN)
Accepts an analog RGB signal from a PC.
Note: For timing data this connector supports, refer to
p. 9 "Timing data chart for PC input".
!4 Audio input connector (AUDIO IN)
With an audio cable connection, this connector accepts
an audio signal from an external device and supplies the
signal to the built-in speaker.
!5 Audio output connector (AUDIO OUT)
Supplies an audio signal accepted by the AUDIO IN
connector to another external device.
@1
@2
@3
@4
!7 !9
!6 !8 @0