Parkside POFA 12 A2 Manual Del Usuario página 27

b) Do not operate power tools in
explosive atmospheres, such as
in the presence of flammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
c) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to lose
control.
2) Electrical safety
a) Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapt-
er plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of elec-
tric shock
b) Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and re-
frigerators. There is an increased risk
of electric shock if your body is earthed
or grounded.
c) Do not expose power tools to
rain or wet conditions. Water enter-
ing a power tool will increase the risk of
electric shock.
d) Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk of
electric shock.
e) When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
f) If operation of the power tool in
a damp environment is unavoid-
able, please use a residual cur-
rent circuitry. The use of a residual
current circuitry reduces the risk of an
electric shock.
3) Personal safety
a) Stay alert, watch what you are
doing and use common sense
when operating a power tool.
Do not use a power tool while
you are tired or under the influ-
ence of drugs, alcohol or medica-
tion. A moment of inattention white op-
erating power tools may result in serious
personal injury.
b) Use personal protective equip-
ment. Always wear eye protec-
tion. Protective equipment such as dust
mask, non-skid safety shoes, hard hat,
or hearing protection used for appro-
priate conditions will reduce personal
injuries.
c) Prevent unintentional starting.
Ensure the switch is in the off-po-
sition before connecting to power
source and/or battery pack,
picking up or carrying the tool.
Carrying power tools with your finger on
the switch or energising power tools that
have the switch on invites accidents.
d) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the power
tool in unexpected situations.
f) Dress properly. Do not wear
loose clothing or jewellery. Keep
GB IE
27