Setting The Dynamic Soundstage Organizer; (Dso) - Sony CDX-M630 Manual De Instrucciones

Adjusting the equalizer curve
1
Press (MENU).
2
Press M or m repeatedly until "EQ7
Tune" appears, then press (ENTER).
3
Press < or , to select the desired
equalizer curve, then press (ENTER).
Each time you press < or ,, the item
changes.
4
Select the desired frequency and level.
1 Press < or , to select the desired
frequency.
Each time you press < or ,, the
frequency changes as follows:
62 Hz y 157 Hz y 396 Hz y 1.0 kHz
y 2.5 kHz y 6.3 kHz y 16 kHz
2 Press M or m to adjust the desired
volume level.
The volume level is adjustable by 1 dB
steps from –10 dB to +10 dB.
To restore the factory-set equalizer curve,
press (ENTER) for 2 seconds.
5
Press (ENTER).
After the effect setting is complete, the
display returns to the normal playback mode.
20
Setting the Dynamic
Soundstage Organizer (DSO)
If your speakers are installed into the lower part
of the doors, the sound will come from below
and may not be clear.
The DSO (Dynamic Soundstage Organizer)
function creates a more ambient sound as if there
were speakers in the dashboard (virtual
speakers).
You can store the DSO setting for each source.
1
Press (SOURCE) to select a desired
source.
2
Press (DSO) to select "1, 2, 3" or "off".
To cancel the DSO mode, select "DSO off."
After 3 seconds, the display returns to the
normal playback mode.
Notes
• Depending on the type of car interior or type of
music, DSO may not have a desirable affect.
• If FM broadcasts are difficult to hear, set DSO to off.