Assembly; Set Protective Hood; Installing/Changing The Cutting/Grinding Disc - Parkside PWSA 12 B1 Manual De Instrucciones

GB IE
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.
Observe the safety infor-
mation and notes on char-
ging and proper use as
shown in the instruction
manual for your battery
and charger from the Park-
side X 12 V Team series. A
detailed description of the
charging process and further
information can be found in
the separate operating inst-
ructions.

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other peo-
ple.

Set protective hood

Adjust the protective hood such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective hood must also be posi-
tioned such that the sparks cannot ignite
combustible parts, including those in the
surroundings.
34
The device must only be op-
erated with the protective
hood mounted.
1. Remove the battery (9). Press the bat-
tery release buttons (8) and pull the
battery (9) out of the tool.
2. Turn the protective hood (1) into the
working position. The closed side of
the protective hood must always face
the operator.
Installing/changing the
cutting/grinding disc
Before initial operation,
check the tightness of the
clamping screw (3).
1. Press the spindle retaining tab (4) and
keep it pressed.
2. Loosen the clamping screw (3) with the
Allen key (11). You can now release
the spindle retaining tab (4).
3. Position the desired cutting/grinding
disc (2) on the mounting flange (12).
The label on the cutting/grinding disc
should always face the tool.
4. Reposition the clamping flange (13).
The side of the clamping flange (13)
with recess generally points to the at-
tachment tool and thus to the cutting/
grinding disc (2). The side with the
marking on the clamping flange
must be visible.
5. Press the spindle
tighten the clamping screw (3) using
the Allen key (11). You can now re-
lease the spindle retaining tab
If the direction of rotation is marked
on your cutting/grinding disc,
make sure that it matches the direc-
tion of rotation mark on the tool.
retaining tab (4) and
(4).