Electronics; Functioning Of The Programmable Input; Alignment - SICK WTT190L-A Serie Instrucciones De Operación

3.3

Electronics

3.4

Functioning of the programmable input

3.5

Alignment

8020032.17U4 | SICK
Subject to change without notice
The sensors must be connected in a voltage-free state (U
the graphics [B] must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
brn
+(L+)
wht
Q
a
blu
–(M)
blk
Q1
gra
MF
in
Figure: B: WTT190L-A15x2B
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (Graphic B):
MF = multifunctional, programmable input
in
PNP mode Deactivated
Active
NPN mode Deactivated
Active
The programmable input must be active for the durations specified below (e.g., U
> 10.0 V in PNP mode ) in order to set the corresponding functions. For a description of
the available functions and how to select them via the menu, see
output, switching output, and other sensor configurations via the menu", page 9
Function
Laser shutdown
External teach-in Q1
Align the sensor with the object. Select the position so that the red emitted light beam
hits the center of the object. You must ensure that the optical opening (front screen) of
the sensor is completely clear [F]. We recommend making the adjustments using an
object with a low remission.
1
brn
+(L+)
2
wht
Q
a
3
blu
–(M)
4
blk
Q1
5
gra
MF
in
Figure: B-2: -A35x2
> 0 V) once all electrical connec‐
V
Value Notes
< 5.0 V Also deactivated when not connected
> 10.0 V Max. applied voltage not higher than
UV
> 10.0 V Max. applied voltage not higher than
UV
< 4.0 V Also active when not connected
Minimum duration
4 ms
4 ms
COMMISSIONING
= 0 V). The information in
V
1
brn
+(L+)
2
wht
Q
a
3
blu
–(M)
4
blk
Q1/MF
in
Figure: B-3: -A22x2
"Setting the analog
Maximum duration
-
-
3
7