Care And Maintenance; Troubleshooting - Harbor Breeze LP8018LAZ Manual De Instrucciones

WALL CONTROL OPERATING INSTRUCTIONS (Continued)
3. Select the desired fan speed using the rotary switch located
on the fan housing. Clockwise rotation of the switch results in a
continuous speed cycle of: High / Medium / Low / Off. (Fig. 19)
NOTE: Medium and low settings will only function properly
when wall control is set in the high speed setting.

CARE AND MAINTENANCE

• Periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning,
use only a soft brush or lint free cloth to avoid scratching the finish. Abrasive and/or non-abrasive
cleaning agents are not required and should be avoided to prevent damage to the finish.
Do not use water when cleaning your ceiling fan. It could damage the motor or the
CAUTION:
finish and create the possibility of electrical shock.

TROUBLESHOOTING

Do not install or use fan if any part is damaged or missing.
WARNING:
Problem
Fan will not start
Fan sounds
noisy
Fan wobbles
excessively
Possible Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections
to the fan, or loose switch wire
connections in the switch
housing.
1. Motor noise caused by solid
state variable speed control.
1. Clevis nut in hanger
bracket/downrod is loose.
Corrective Action
1. Check main and branch circuit fuses or
circuit breakers.
2. Check line wire connections to fan and
switch wire connections in the switch
housings.
Make sure main power is
CAUTION:
turned off !
1. Some fan motors are sensitive to signals
from solid-state variable speed controls.
Solid-state controls are not recommended,
choose an alternative control method.
1. Tighten clevis nut securely in hanger
bracket/downrod support
10
Fig. 19