Dacor DTI36M977BB Manual Del Usuario página 62

Troubleshooting
Symptom
The boost
function has
been deactivated
or cannot be
activated.
The cooktop
responds unusually
or can no longer be
operated correctly.
There are cracking
or popping sounds.
There are beeping
sounds.
62 English
NZ9500K_MOD_DTI36M977BB_DG68-00899A-02_EN+MES+CFR.indb 62
Possible cause
A cooking position is
already paired, and the
cooktop is too hot.
The power level is set
between 1.0 and 3.0.
And two pots are put on
the Flex Zone.
Occurs if buttons are
repeatedly pressed.
Solution
You can activate the boost function only
once for a single burner. If a second
cooking position is switched on or is
already in operation, the boost function
will not be available or is deactivated,
and the cooking position returns to
power level 9.0.
The cooktop may be hot. Wait until the
cooktop cools down.
Disconnect the appliance from the
electric supply by switching the circuit
breaker off to the off position for 15
seconds.
This is normal. The strength of sound
depends on the number and the size of
the pots.
Cookware is on the touch buttons, and
hot cookware can damage the buttons.
Remove the cookware.
2017-08-01 12:01:25