Mounting Instructions - Fein GRIT GXC Manual De Instrucciones

3 94 10 011 00 0.book Seite 13 Montag, 6. August 2007 3:57 15
GXC
Be careful when working short or thin material.
When guiding in and removing, the grinding belt
or the brake wheel can catch hold of your hands
and cause serious injuries.
Be careful after switching off. The machine will
run on for approx. 1 minute. Carry out adjust-
ments and maintenance only when the grinding
belt has come to a complete stop.
At a glance.
1 Belt tension lever (GX 75)
2 Cover/stop (GX 75)
3 Spark guard (GX 75)
4 Star-knob bolt for dust collector (GX 75)
5 Grinding rest (GX 75)
6 Dust collector (GX 75)
7 Lever for swivel device (GX 75)
8 Side cover (GX 75)
9 Mounting bolts
10 Bolts, Adjustment GXC
11 Drive motor for brake wheel
12 Clamping lever for brake-wheel parallelism
13 Handle
14 Basin
15 Rollers
16 Lever for applying the brake wheel
17 Brake wheel
18 Clamping lever
19 Star-knob bolt for brake wheel inclination
20 Clamping lever for brake-wheel clearance
21 Connection socket
22 Crank for feed pressure
23 Gap opening
24 Guide rail
25 Wing nut
26 Bolt for guide-rail adjustment
27 Coolant hose with nozzle
28 Shut-off valve
29 Holder
30 On/Off switch, coolant pump
31 Connection sleeve for return of coolant
32 Coolant container
Intended use of the machine.
The GXC cylindrical grinding device is intended
exclusively for grinding and polishing of steel
pipes, light metal pipes as well as for solid round
steel bars with diameters ranging between
D = 10 - 100 mm.
The GXW coolant unit is intended for cooling of
the work piece.

Mounting instructions

(Figure 1 + 2 + 3).
Belt grinder GX 75.
Before any work on the machine itself, pull
the power plug from the socket outlet.
Dismount the spark guard (3).
Dismount the grinding rest (5), the dust col-
lector (6) and the star knob bolt (4).
Open the side cover (8).
Loosen the belt tension lever (1) and
remove the grinding belt.
Close the side cover.
Loosen the lever for the swivel device (7)
and position the belt grinder approx. level.
Cylindrical grinding module GXC.
Take the module out of the packaging and
mount the accessories as described in the
data sheet and the instruction DVD.
Position the cylindrical grinding device
against the belt grinder and align the drill
holes of the screws (9).
Connect both units with the four bolts (9)
and the bolts with wing nuts (25).
Tilt the machine to a light forward position.
Clamp the lever for the swivel device (7).
Loosen the two bolts (10) underneath the
basin (Fig. 2) and align the bottom of
the GXC to the floor.
Fasten the two bolts (10) underneath the
basin (Fig. 2).
An qualified electrician must connect the
loose cable to the power point in the GX 75
switch according to wiring diagramm (see
appendix).
EN
13