Fein GRIT GXC Manual De Instrucciones página 15

3 94 10 011 00 0.book Seite 15 Montag, 6. August 2007 3:57 15
GXC
Adjusting the feed pressure
Adjust the feed pressure of the brake wheel
against the work piece with the crank (22):
– Turning in clockwise direction: High feed
pressure.
– Turning in anticlockwise direction: Low feed
pressure.
Excessive feed pressure can lead to increased
wear of the brake wheel and the grinding belt!
Switching ON and OFF.
Do not switch the machine on until all
required adjustments have been carried out.
Make sure that no work piece is inserted in the
machine.
Plug the plug of the cylindrical grinding
device into the socket outlet on the belt
grinder.
Switching the belt grinder/cylindrical
grinding device on/off
Switch the belt grinder on.
The cylindrical grinding device is switched
on automatically.
Check the rotation direction of the brake
wheel. The rotation direction of the motor
may only be reversed by a qualified electrician.
Switch the belt grinder off after the work
cycle. The cylindrical grinding device is
switched off automatically.
Emergency OFF pushbutton
In situations of danger, push the red emer-
gency OFF pushbutton on the belt grinder to
switch both machines off.
Switching the coolant pump on/off
Set the switch (30) to position "1". The
coolant pump must always be switched on
for high material removal.
Operating instructions.
Wear safety glasses.
Before starting to work, ensure that all pre-
viously described adjustments have been
properly set and checked.
Grinding pipes
Tilt the brake wheel back with lever (16).
Insert the work piece at least 30 mm into
between the contact pulley and the brake
wheel (Fig. 6).
Open the shut-off valve (28). Regulate the
coolant rate with the valve (28).
Tilt the brake wheel forward again with
lever (16) so that the work piece rotates and
runs through the machine.
Pull lever (16) back again when the work
piece is still approx. 30 mm deep in the pipe
guide (Figure 6).
Take the work piece out of the machine.
When the feed speed is too high or too
low, the inclination of the brake wheel
must be changed.
Repair and customer service.
Before any work on the machine itself, pull
the power plug from the socket outlet.
Repairs may be carried out only by quali-
fied persons in conformity with the valid
regulations.
For repairs, we recommend our FEIN customer
service centre, the FEIN authorised service cen-
tres and FEIN agencies.
Carry out the following maintenance regularly:
Daily maintenance
Remove metal dust and adherent grinding
dust with compressed air.
Clean the basin (14). If required, remove any
clogs in the drain system.
Empty the coolant tank. Separate and dis-
pose of coolant and metal dust.
Warranty and liability.
The warranty for the product is valid in accord-
ance with the legal regulations in the country
where it is marketed.
In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's guar-
antee. For further details on this, please contact
your specialist dealer, your national FEIN repre-
sentative, or the FEIN customer service centre.
EN
15