Assembly Of The Wheels; Assembly Of The Toddler Roller - Emmaljunga Classic Manual De Instrucciones

Assembly of the wheels

1
2
2

Assembly of the Toddler Roller

1
6
1
3
5
4
2
Manual Toddler Roller Classic / Big Star Classic v. 2.2
• Mount the wheel assembly on the board with the washer between the
1
wheel assembly and the nut.
• Use the ring spanner to tighten the nut until the upper end of the nut is
level with the end of the bolt..
WARNING!
• Make sure that this is done with both wheels.
• Check that the wheel and the nut are securely attached.
• Brake the pram.
• From below click the Adaptors connections (1) onto the u-shaped tube
2
on both sides of the pram.
7
The Adaptor connections shall be pointing up as shown in the picture.
Make sure that the square shaped hole on the Adaptor connections is
pointing outwards on the pram.
8
• Place the Adaptor (2) between the Adaptor connections. Use the two
M5 bolts (3) and M5 washers (4) and tighten the Adaptor using the al-
len key.
IMPORTANT!
• Tighten the bolts until it´s impossible to slide the Adaptor connecntions
along the tube (5).
• Place the Toddler connections (6) over the Adaptor and fasten both
locks down (7).
• Make sure that the Spacers (8) are placed between the Adaptor con-
nections and the Toddler connections on both sides.
VARNING!
• These steps are verty important for securing the Toddler roller to the
pram.
• Always check that the Toddler roller is correctly attached before use.
• Never remove or attach the Toddler roller from the Adaptor when a
child is on the roller.
• När du monterar eller tar loss åkbrädan från vagnfästet får inga barn
befinna sig på åkbrädan.
• Always check that the Toddler roller doesn´t affect the brake system on
the pram.
Remove the Toddler roller from the Adaptor
• Open the locks and remove the Toddler Roller from the Adaptor.
Properly attached Toddler roller to Classic/Smart chassis.
27