Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7. Turn-On, Cold Start & Turn-Off Procedures
Note: Refer to 3. Operation Panel for details on the operation panel and the display meaning.
7.1 Turn-On Procedure
After the UPS is connected to the AC utility, the AC utility supplies power to the UPS. The UPS is initially set In Standby Mode.
To turn on the UPS, press and hold the
7.2 Cold Start Procedure
Even when there is no utility power, the UPS can be turned on. Press and hold the
one beep and the UPS will start up and run in Battery Mode.
7.3 Turn-Off Procedure
1. To turn off the UPS in On-line Mode, press and hold the
inverter will turn off and the UPS will transfer to Standby Mode.
The UPS will keep charging the batteries when the UPS is in Standby Mode, even though the
To fully turn off the UPS, unplug the input power cord.
2. To turn off the UPS in Battery Mode, press and hold the
UPS will turn off its output.
8. Alarm
Battery Mode: The audible alarm beeps once every 2 seconds.
Low Battery: The audible alarm beeps once every 0.5 second.
Bad Battery/Battery Replacement*: The audible alarm beeps once every 2 seconds.
Overload:
1. Overloaded 105-125%: The audible alarm beeps once every 2 seconds.
2. Overloaded 125-150%: The audible alarm beeps once every 0.5 second.
Fault: The audible alarm beeps continuously for 5 seconds if the UPS detects an internal fault.
* After reconnecting or replacing the batteries, it may take a short time for the UPS to switch off the alarm automatically. If, after a period of
time, the audible alarm still exists, the user should manually initiate a battery test (press and hold the
it after hearing one beep) to clear the alarm.
button for 3 seconds. Release it after one beep.
button for 3 seconds. Release it after hearing one beep. The
button for 3 seconds. Release it after hearing one beep. The
25
button for 3 seconds. Release it after
button has been pressed.
button for 3 seconds and release
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
