13
IMPORTANT!
Please remove the SUNTEC H13-HIGH-PERFORMANCE-COMBO-FILTER from the unit, if you wish to operate
it in cooling, dehumidifying, fan and heating mode. The SUNTEC H13-HIGH-PERFORMANCE-COMBO-FILTER
is only intended for the use of the air purification (fresh-function). For more information, please refer to the chapter
"Operation for Air Purifying /"fresh"-function"/ SUNTEC H13-HIGH-PERFORMANCE-COMBO-FILTER
Installation
The unit should stand 50 cm away from other objects because they can strongly influence performance of the
device (Fig. 3).
Warning: Before using this unit, you should let it stand straight for at least 24 hours.
The unit can be easily moved between rooms, but please note the following:
①
Cooling Operation
A. COOLING IN INDOOR OPERATION
The FUSION CleanAir unit stands in the room to be cooled.
Please take out the SUNTEC H13-HIGH-PERFORMANCE-COMBO-FILTER and insert the active carbon
filter. Connect the exhaust hose and the exhaust hose connector to the FUSION CleanAir unit as
displayed in the illustration;
The warm extract air must be emitted from the room via the exhaust hose. This can be executed e.g. via
a tilted window, a door or wall aperture. Make sure that no warm outside air can enter the room. For
effective cooling, we recommend our selection of various accessories, for example Window kit (incl. in
the package) which reduce or prevent entry of warm air into the room.
Set the function to „COOLING". Set the target temperature using the temperature control. The settable
temperature range is between 16°C and 31°C target temperature. The FUSION CleanAir unit must only
be used in an ambient temperature of maximum 35°C.
B. COOLING IN OUTDOOR OPERATION
The FUSION CleanAir unit is outside the room to be cooled.
14
15
16
17
20