McQuay C Serie Manual Del Usuario página 7

Please ensure that the following steps are taken:
• Check the gradient for drainage flow as recommended in Figure B.
• Provide clearance for easy servicing and optimal air flow as shown in Figure C.
• The indoor unit must be installed such that there is no short circuit of the cool discharge air with the warm return air.
• Do not install the indoor unit where there is direct sunlight shining on the unit. The location should be suitable for piping and
drainage installation. The unit must be a large distance away from the door.
Install Suspension Bolts
1 Install the suspension bolts so that it can support the
indoor unit.
2 Adjust distance to ceiling before installation.
3 Refer to dimension given to install the unit.
Installation Ceiling Type
5mm (Min.)
250mm (Max.)
UNDER CEILING INSTALLATION
Install Indoor Units
1 Insert the suspension bolts into the fitting of the hanger
bracket.
2 Set the nuts and washer on both side of the metal
fittings.
3 Secure it with nuts.
Top Panel Of Unit
10mm
10mm
1-5
Drainage Pipe Side
Utensils, furnitures or built-in
architectural features must not
protrude more than 250 mm
300mm (Min.)
Ceiling Board
Fig. C
Fig. D