CST/BERGER 58-iLMXL Manual De Instrucciones página 20

Switching On and Off and Changing Operating Modes
Do not point the laser beam at persons or animals and do not
look into the laser beam yourself, not even from a large dis-
tance.
Do not leave the switched on measuring tool unattended and
switch the measuring tool off after use. Other persons could be
blinded by the laser beam.
– To switch on the measuring tool, press the operating mode button
2.
LED 1
Lights up green
Lights up red
Lights up red and
laser beam flashes
Flashing
– Press operating mode button 2 as often as required until the
requested operating mode is set.
Operating Mode
20 | English
Operating Condition
Measuring tool switched on and within the
self-levelling range
Measuring tool in manual operation
Measuring tool not within the self-levelling
range
Batteries low;
measuring tool still operative, but laser beams
becoming weaker
Horizontal laser beam
Vertical laser beam
Applicational Example
1 609 929 T56 • 24.2.09