Black+Decker KA280 Traducción De Las Instrucciones Originales página 9

Autoselect® dial application chart
Setting Application
Small area sanding.
Allows you to easily get into
tight areas
Large sanding.
Allows you to get up to the
edge of a 90° angle
Flush sanding.
Allows you to get up to the
edge of a 90° angle
Large area sanding.
Allows you to remove the
most amount of paint quickly.
Autoselect® dial application chart
This tool has an automatic brake system. When the tool is
not on the work surface, this feature keeps the speed of the
disc below the speed of the motor. When the tool is switched
off, the disc will stop very quickly.
Emptying the dust canister (fig. P & Q)
The dust canister (9) should be emptied after every ten
minutes of use.
Pull the dust canister (9) to the rear and off the tool.
u
Remove the cover (24) by twisting it counter clockwise.
u
Hold the dust canister (9) with the filter (25) facing down
u
and shake the canister to empty the contents. Shake the
cover (24) to empty the contents.
Accessories
The accessories supplied with your sander depend upon the model that you have purchased. All the accessories listed below
are available in our Piranha® range. If you require an accessory that is listed below but is not supplied with your sander please
visit our website at www.blackanddecker.eu.
Item
Large detail sanding base (6).
Random orbit sanding base (5).
Detail finger (8).
Recommended base
Detail finger attachment
Large detail base, tip
facing forward
Flush sanding base,
90° edge facing
forward.
Random orbit base
Description
(Original instructions)
Orange
Blue
Blue
Green
Refit the cover (24) onto the dust canister, twisting it
u
clockwise until it locks into place.
Refit the dust canister (9) onto the tool.
u
Cleaning the dust canister filter
The dust canister filter is re-usable and should be cleaned
regularly.
Empty the dust canister (9) as described above.
u
Pull the filter (25) off the dust canister.
u
Shake off excess dust by tapping the filter into a dustbin.
u
Warning! Do not brush or use compressed air or sharp
objects to clean the filter. Do not wash the filter
Replace the filter (25).
u
Refit the cover (24).
u
Refit the dust canister (9) onto the tool.
u
Purpose
For medium to large areas. The large detail base can be
used to sand into corners and to the edge of the workpiece.
For large areas. The random orbit base can be used for
curved surfaces and when you need a high-quality finish.
For small hard-to-reach areas. The detail finger can be
used for light sanding and for sanding into corners.
ENGLISH
Base colour Speed setting
(1) Low
(1) Low
(2) High
(2) High
9