Cleaning - MSA AirMaXX alpha Serie Manual Del Usuario

MSA
4.3.

Cleaning

Pre-cleaning
(1) Open cylinder valve(s) of the mounted compressed air cylinder(s) fully.
(2) Remove rough dirt from breathing apparatus with water hose. Here, we
recommend using a mild detergent.
(3) Close cylinder valve(s), release air from apparatus with lung governed
demand valve.
l
Cleaning,
(1) Remove compressed air cylinder(s) (see 3.11).
(2) Clean compressed air breathing apparatus manually using brush, damp
cloth or similar.
(3) Dry apparatus completely in a drying cabinet at max. 60°C.
Cleaning, heavy soiling
(1) Remove compressed air cylinder(s) (see 3.11).
(2) Disconnect lung governed demand valve from medium pressure line.
(3) Open line holder and unbutton shoulder pads.
The carrying and hip belts of the compressed air breathing apparatus
are fastened in the carrying plate with metal buckles. To remove the
belts, you must pull up the buckles slightly, twist and push them out of
the slots in the carrying plate.
(4) Slide shoulder pads to lowest position in the lateral guide slots of the slide
carrying plate, tilt buttons a little towards outside and take pads out of guide
slots.
(5) Unbutton shoulder pads and hip belt from carrying plate.
(6) Press retaining pin (see Fig. 10) of the multi-channel tube slanting
downwards and remove.
(7) Do the same on the other side of the carrying plate.
(8) Remove multi-channel line from the guide on the carrying plate.
GB
MAINTENANCE AND CARE OF THE SCBA APPARATUS
ight soiling
AirMaXX SL
15