Holding And Controlling The Power Tool - Stihl RG-KM Manual De Instrucciones

6 IMPORTANT SAFETY INSTRUCTIONS
– Always keep the blades sharp.
￭ Using a KombiTool that is modified, damaged, improperly
adjusted or maintained, or not completely and securely
assembled can lead to a malfunction and increase the risk
of serious personal injury or death.
– Never operate a KombiTool that is modified,
damaged, improperly maintained or not completely
and securely assembled.
– Always check your unit for proper condition and
operation before starting work.
– If your KombiTool or any part is damaged or does
not function properly, take it to your authorized
STIHL servicing dealer. Do not use the unit until the
problem has been corrected.
￭ Before switching on or starting your power tool, take the
following steps to reduce the risk of personal injury from
thrown objects, loss of control or inadvertent contact with
the blades:
– Be sure that the KombiTool and its blades are clear
of you and all other obstructions and objects,
including the ground.
– Read and follow the instructions for switching
on/starting the power tool in the manual for the
KombiEngine/KombiMotor being used.
0458-811-8621-A
6.5.2

Holding and Controlling the Power Tool

WARNING
￭ To maintain a firm grip and properly control your power
tool:
– Keep the handles clean and dry at all times. Keep
them free of moisture, pitch, oil, grease and resin.
￭ Operating the power tool with one hand may lead to loss
of control and is extremely dangerous. To reduce the risk
of serious or fatal injury to the operator or bystanders from
loss of control:
– Never attempt to operate the power tool with one
hand.
￭
￭ To reduce the risk of serious or fatal injuries to the
operator or bystanders from loss of control:
– Always hold the power tool firmly with both hands
when you are working.
– Wrap your fingers tightly around the handles,
keeping the handles cradled between your thumb
and forefinger (see illustration of the KMA 130
above).
– During operation, the operator's right hand must grip
the rear handle and the operator's left hand must
hold the front handle (see illustration of the KMA 130
above). This applies to all operators, even those who
are left-handed.
– Position the power tool so that all parts of your body
are clear of the KombiTool and its blades.
English
7