DENTSPLY Sani-Tip L-3 Manual Del Usuario página 4

L-2 conVersIon KIt for MInIMatIc aIr/Water sYrInges
L-2 conVersIon KIt adaPter InstaLLatIon InstrUctIons
1
1. Remove all existing nozzle parts. Nozzle
receptacle must be free of all obstructions
and/or loose parts before proceeding. Use 6mm
hex key provided to remove existing adapter.
2
3
4
®
1. Sani-Tip
2. Thumb Nut
3. Plastic Cone
n
2. Verify new adapter
o p
o-rings and in
position as shown.
3. Hand-thread adapter
into syringe. Use hex
key provided to tighten.
4. O-ring 7. O-ring
5. Adaptor
6. O-ring
has
4
m
4. Verify o-ring is in
place inside large
opening of white
l
plastic cone .
5
5. With o-ring in place,
firmly snap large end
of white plastic cone
over adapter rim.
6
6. Hand-thread thumb
nut onto adapter. Do
not tighten until new
tip has been inserted.
Installation is complete.