Tabla de contenido
Publicidad
ENGLISH
INTRODUCTION
CAUTION!
Some general and detailed machine information is not included in this guide.
Please refer to Instruction for Use Manual on supplied CD-ROM reading by Adobe
NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
GUIDE PURPOSE AND CONTENTS
The purpose of this
Quick Start Guide
properly.
For
information about technical
and
safety conditions etc., please refer to Instruction for Use manual on supplied
Before performing any procedure on the machine, the operators and qualified technicians must read
for Use
manual. Contact our company
further information.
HOW TO KEEP THIS GUIDE
The Quick Start Guide must be kept near the machine, inside an adequate case, away from liquids and other
substances that can cause any damage to it.
DECLARATION OF CONFORMITY
Declaration of Conformity is supplied with the machine and certifies machine conformity with the law in force.
NOTE
The copies of the original declaration of conformity are provided together with the machine
documentation.
ACCESSORIES AND MAINTENANCE
All the necessary operation, maintenance and repair procedures must be made by qualified personnel,
appointed repair center. ONLY original or approved spare parts and accessories can be used.
Contact
our company
customer service for any service or purchase of accessories or spare parts if necessary.
CHANGE AND IMPROVEMENT
We committed to continuous improvement of its products, the company reserves the right to the machine changes
and improvements without informing in additional.
SCOPE OF APPLICATION
The scrubber applies to commercial and industrial use. It is suitable for cleaning smooth and solid floor, operating
by a qualified personnel in safety circumstance. It is not suitable for outdoor use or carpet or rough floor cleaning.
MACHINE IDENTIFICATION DATA
The machine serial number and model name are marked on the serial label (4).
This information is useful. Use the following table to write down the machine identification data when requiring
spare parts for the machine.
MACHINE MODEL.....................................................................
MACHINE SERIAL NUMBER....................................................
TRANSPORT AND UNPACKING
When the carrier delivers the machine, make sure the packaging and machine are both whole and undamaged. If
any damaged, make the carrier know the damage and before accepting the goods, reserve the right in compensation
is to provide the operator with
characteristics,
operation,
in case of doubts concerning the interpretation of the instructions
1
QUICK START GUIDE
all basic
information to use the machine
machine inactivity, maintenance, spare
CD-ROM.
®
®
Reader
.
parts
the Instruction
or for any
our company
Publicidad
Tabla de contenido
