Tabla de contenido
Publicidad
ENGLISH
MACHINE START AND STOP
Starting the machine
1.
Firstly connect power, adjust squeegee, install pad-holder or brush and regulate volume of water, then make
them to be ready for the run status according to previous sections when you operate the machine.
2.
Lay down the squeegee by squeegee lifting handle.
Press the power switch (45), brush switch (46) and vacuum switch (47) to on position "-".
3.
4.
Start cleaning by holding machine handle and press the safety switches, and then push the machine.
Stopping the machine
Follow below steps to stop the machine.
1.
Release the safety switches (1), and then brush/pad-holder stop working.
Press the brush switch (46), vacuum switch (47) and power switch (45) to off position "o".
2.
4.
Lifting the squeegee (A, Figure 8) from the ground by squeegee lever (14).
5.
Hold the machine handlebar (2) and lean back machine until assist wheels (B, Figure 8) touch the ground.
6.
After machine is whole stop, uninstall the brush/pad-hold.
NOTE
To thoroughly suck dry the water in drain hose, when you just turn off the vacuum switch and keep
the power switch on, the vacuum will stop after five seconds delay.
MACHINE OPERATION (SCRUBBERING AND DRYING)
1.
Start the machine as shown in previous paragraphs。
2.
While keeping both hands on the handlebar press the safety switch (1), then manoeuvre the machine and start
scrubbing/drying the floor.
If necessary, stop the machine then adjust squeegee according to section "Adjusting balance of squeegee".
3.
4.
If necessary, stop the machine then adjust the solution quantity by using the valve (38).
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad-holder when the machine
stops in one place.
NOTE
For correct scrubbing/drying of floors at the corner of walls, Nilfisk suggests to go near the walls
with right side of the machine as shown in below Figure 9.
Figure 8
Figure 9
9
QUICK START GUIDE
Publicidad
Tabla de contenido
