Date/Time Set Up - Uline H-5819 Manual Del Usuario

BACKLIGHT
At startup, the backlight will automatically turn on
when the scale is in use. Enter this menu to change the
backlight setting.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
Tare
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
Tare
• BK AU – Backlight automatically turns on when the
scale is in use.
• BK ON – Backlight is always on.
• BK OFF – Backlight is never on.
5. Press the ZERO key
Tare
6. Press the TARE key
press the MODE key
HI/LO LIMIT BEEPING SOUND
At startup, the beeping sounds are set to no sound. Enter
this menu to change the beeping sound setting.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
Tare
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key Tare
• Bep 1 – Beeping sounds between the limits.
• Bep 2 – Beeping sounds outside of the limits.
• Bep 0 – No beeping sounds.
5. Press the ZERO key
Tare
6. Press the TARE key
press the MODE key
PAGE 10 OF 33
SETUP MENU CONTINUED
Tare
will be shown on the display.
P1ObFL
until is shown on the
Zero
to enter the menu.
to change the setting.
Zero
to select the new setting.
to view additional menus or
Mode to exit the setup menu.
Tare
will be shown on the display.
P11 bP
until is shown on the
Zero
to enter the menu.
to change the setting.
Zero
to select the new setting.
to view additional menus or
to exit the setup menu.
Mode

DATE/TIME SET UP

Enter this menu to set the date and time.
1. Turn on the scale and press the TARE key
the self-test.
during
PO CAL
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
is shown.
a. d-m-y – Day – Month – Year
b. y-m-d – Year – Month - Day
5. Press the ZERO key
6. Press the TARE key
or date.
a. YY – Year
b. MMDD – Month & Day
c. HHMM – Hours & Minutes
7. Press the ZERO key
change.
8. The active digit will start blinking. Press the
TARE key
during
Press the UNITS key
9. Press the ZERO key
10. Press the MODE key
11. Press the TARE key
press the MODE key
PO CAL
will be shown on the display.
P12 t
Tare
until
Zero
to enter the menu.
Tare until the desired date format
Zero
to select the new date format.
to change the year, month
Tare
Zero
to select the setting to
Tare to change the blinking digit value.
to move to the next digit.
Units
Zero
to confirm.
.
Mode
Tare
to view additional menus or
twice to exit the setup menu.
Mode
Tare
during
i
is shown on the
0721 IH-5819