Check Weighing; Check Counting - Uline H-5819 Manual Del Usuario

LACK OF UNIT WEIGHT
The minimum weight must be at least 20 times the
scale accuracy for accurate calculations. Refer to the
minimum weights chart below.
MINIMUM WEIGHTS
Minimum Sample
Model #
H-5819
H-5820
H-5821
H-5822
If the unit weight is too light, another scale is needed.
Continuing to use this scale will result in less accurate results.

CHECK WEIGHING

Use this mode to set a number for a weighing check.
When the weight of the objects on the platform is less
than or larger than the preset checking number, the
indicators in the lower right hand corner of the display
will show HI, OK or LOW.
Alarm beeping sounds can be enabled to beep when
weights are in or out of limits. See page 9 to enable.
SET CHECK WEIGHT
1. Press the MODE key
the display.
2. To set the high limit, press the HI key
Current high limit will be shown on the display.
3. Key in the high limit by using the numeric keys and
press the ZERO key
4. To set the low limit, press the LO key
low limit will be shown on the display.
5. Key in the low limit by using the numeric keys and
press the ZERO key
CHECK WEIGHT OPERATION
1. Press the MODE key
the display.
2. Place item to be weighed on the scale platform.
Weight will be shown on the display. Scale indicators
will show if weight is out of specified HI/LOW range.
PAGE 6 OF 33
OPERATION CONTINUED
Minimum Piece
Weight Weight
0.002 lb. 0.00005 lb.
0.01 lb. 0.00025 lb.
0.02 lb. 0.0005 lb.
0.04 lb. 0.001 lb.
C nEt
until is shown on
Mode
MR
.
HI
.
Zero
MC
. Current
LO
.
Zero
C nEt
Mode until is shown on
CLEAR CHECK WEIGHT
1. Press the MODE key
the display.
MR
2. Press the HI key
on the display.
3. Enter 0 using the numeric keypad.
4. Press the ZERO key
MC
5. Press the LO key
on the display.
6. Enter 0 using the numeric keypad.
7. Press the ZERO key

CHECK COUNTING

Use this mode to set a number for a counting check. When
the number of objects on the platform is less than or larger
than the preset checking number, the indicators in the lower
right hand corner of the display will show HI, OK or LOW.
SET CHECK COUNT
1. Press the MODE key
the display.
2. To set the high limit, press the HI key
high limit will be shown on the display.
3. Key in the high limit by using the numeric keys and
press the ZERO key
4. To set the low limit, press the LO key
limit will be shown on the display.
5. Key in the low limit by using the numeric keys and
press the ZERO key
CHECK COUNT OPERATION
1. Press the MODE key
the display.
2. Follow counting steps on pages 4-5. Scale indicators will
show if the total quantity is out of specified HI/LOW range.
3. Press the U/N/G key
gross weight and total quantity.
C nEt
until is shown on
Mode
. Current high limit will be shown
HI
.
Zero
. Current low limit will be shown
LO
.
Zero
C PCS
until is shown on
Mode
MR
. Current
HI
Zero
.
MC
. Current low
LO
.
Zero
C PCS
until is shown on
Mode
U/N/G
to display the unit weight,
0721 IH-5819