Enable Weighing Units - Uline H-5819 Manual Del Usuario

5. Add additional items to platform. New data will be
added to memory. Continue until all data is added.
6. To recall data and clear data, see sections above.
UNIT WEIGHT MEMORY
The scale can store and recall up 255 unit weights.
SETTING A UNIT WEIGHT
1. Key in the unit weight by using the numeric keys.
2. Press and hold the PLU key
on the display.
3. Key in the unit weight name using the numeric keys.
Names should be three digits between 001 and 255.
SAV###
4. Once keyed in,
display. The scale makes a beeping sound and
enters the counting mode.
RECALLING A UNIT WEIGHT
1. Place items to be counted on the platform.
2. Press the PLU key
PLU
3. Key in the three digit unit weight name by using the
###
PL
numeric keys.
4. Scale will recall the unit weight and then display the
number of items on the platform.
RS-232
1. Specifications:
• RS-232 output of weighing data
• ASCII CODE
• 600-9,600 Baud
• 8 data bits
• No Parity
2. RS-232 (9-pin d type connector)
Pin 2 RXD
Pin 3 TXD Output
Pin 5 GND
9 Pin D Connector
Scale
Pin 2:
Pin 3:
PAGE 8 OF 33
OPERATION CONTINUED
PLU
. will be shown
PLU
will be shown on the
PLU
. will appear on display.
will be shown on the display.
Input Receiving Data
Transmission Data
— Signal Ground
Computer/Printer
Pin 3
Pin 2
Scale
Pin 5:
NOTE: If data is not getting in your computer/
printer, interchange pin 3 and pin 2 connections.
3. Continuously output protocol.
CONT: WEIGHING MODE
， G
S T S
4. OD-2130D Printer Formats:

ENABLE WEIGHING UNITS

At startup, all weighing units are enabled – lb / oz / g / kg.
Enter this menu to change enabled weighing units.
NOTE: lb. weighing unit cannot be turned off.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
Tare
2. Press the TARE key
display.
3. Press the ZERO key
kg
4. will be shown on the display. Press the TARE key
to select on or off. Press the ZERO key
the new setting.
g
5. will be shown on the display. Press the TARE key
to select on or off. Press the ZERO key
the new setting.
oz
6. will be shown on the display. Press the TARE key
to select on or off. Press the ZERO key
the new setting.
Tare
7. Press the TARE key
press the MODE key
Computer/Printer
Pin 5
k
Tare
will be shown on the display.
P3 Unt
until is shown on the
Zero
to enter the menu.
Zero
to select
Zero
Zero
to select
to view additional menus or
to exit the setup menu.
Mode
g CR LF
during
Tare
to select
Tare
Tare
0721 IH-5819