Set The Average Piece Weight (Apw) - Uline OHAUS DEFENDER 5000 Manual Del Usuario

NOTE: The I/Os will only work when the I/O
Option Board has been installed.
The option I/O board provides two isolated inputs and
four dry-contact normally open relay outputs which can
be used for simple process weighing.
1. Press the button
User
Menu
to enter the Main Menu.
(See Figure 37)
2. With the button corresponding to the ▼ icon, go
down the list and highlight Application Mode. Enter
this submenu by pressing the button corresponding
to the icon. (See Figure 37)
3. In the Application
Mode menu, enter the
Weighing submenu.
(See Figure 38)
4. The Weighing submenu
is now displayed.
Select the list item
and press the button
corresponding to the
icon to change
the setting as desired. After completion of I/O setup,
press the softkey corresponding to the
return to the main application screen. (See Figure 39)
COUNTING
Use this application to count samples of uniform weight.
1. Press the
Library
Mode
button until the icon
corresponding to
Counting is displayed
on the screen. The
default (or last) Average Piece
Weight (APW) is displayed. (See Figure 40)
2. Set the APW value (see below) and then place
objects on the pan to display the number of pieces.

SET THE AVERAGE PIECE WEIGHT (APW)

NOTE: It is recommended that the APW is larger
than 1d. If APW is between 0.05d and 1d, a
warning message will be displayed and the
information line will show "APW is too small!". If
APW is less than 0.05d, an error message will
appear, and the APW value cannot be stored.
PAGE 14 OF 101
APPLICATIONS CONTINUED
There are two methods to set the APW:
ENTERING A KNOWN APW
1.
2. Press the softkey
Figure 37
1. Alternatively, first
Figure 38
2. Press the softkey
Figure 39
icon to
3. After editing, press the
CALCULATING AN APW
Figure 40
1.
2. Press the softkey
Method 1
Key in the Piece Weight
using the alphanumeric
keypad. (See Figure 41)
corresponding to
APW
the icon.
(See Figure 42)
Method 2
press the softkey
corresponding to the
APW
icon to enter the
submenu for setting the
APW. (See Figure 43)
corresponding to
the icon to edit
the APW value using
the alphanumerical
keypad. (See Figure 44)
softkey corresponding
to the icon for
confirmation, and
then press the softkey
corresponding to the
icon to exit the submenu. (See Figure 45)
Method 1
Place the sample on
the pan and then key
in the number of
pieces using the
alphanumeric keypad.
(See Figure 46)
corresponding to
the PCS icon for
confirmation. The
terminal will calculate
the new APW using the
number of pieces.
(See Figure 47)
Figure 41
Figure 42
Figure 43
Figure 44
Figure 45
Figure 46
Figure 47
0621 IH-8105