Auto Power Off - Uline H-5819 Manual Del Usuario

AUTO POWER-OFF
When the auto power-off time is enabled, the scale will
automatically turn off when there has been no load on
the platform and the scale is stable at zero position for a
specified period of time in minutes. At startup, the scale
will automatically turn off after five minutes.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
Tare
2. Press the TARE key
display.
3. Press the ZERO key
CLEANING
CAUTION! Disconnect the unit from the power
supply before cleaning.
Use a mild detergent for the display, keypad and
housing.
OPERATING ISSUE / ERROR CODE
-OL-
Bat lo
Blinking Display
Faded Display
Err 4
FAIL
Load Lo
Load Hi
If the problem persists or the troubleshooting section does not resolve or describe your problem, contact
Uline Customer Service at 1-800-295-5510.
PAGE 11 OF 33
SETUP MENU CONTINUED
Tare
will be shown on the display.
P13 SP
until is shown on the
Zero
to enter the menu.
TROUBLESHOOTING
CAUSE
Maximum capacity exceeded.
Low Battery.
Scale needs to be recalibrated.
Calibration did not work.
Calibration weight is too light.
Calibration weight is too heavy.
4. Press the TARE key
• Of 0 – Auto power-off is off.
• Of 3 – Auto power-off at 3 minutes.
• Of 5 – Auto power-off at 5 minutes.
• Of 15 – Auto power-off at 15 minutes.
during
• Of 30 – Auto power-off at 30 minutes.
5. Press the ZERO key
6. Press the TARE key
press the MODE key
MAINTENANCE
WARNING! Do not use solvents, chemicals,
alcohol, ammonia or abrasives.
Use a stainless steel cleaning solution for the stainless
steel platform.
Apply cleaner to a clean, damp cloth and wipe surface.
Dry thoroughly.
1-800-295-5510
uline.com
Tare to change the setting.
Zero
to select the new setting.
Tare
to view additional menus or
to exit the setup menu.
Mode
RECOMMENDATIONS
Remove load from the platform.
Recharge the battery.
Recalibrate the scale.
Recalibrate the scale.
Use calibration weight that is equal to or exceeds
minimum calibration weight.
Use calibration weight that is equal to or less than
maximum calibration weight.
0721 IH-5819