Check Weighing (Default); Check Counting - Uline OHAUS RANGER 7000 Manual Del Usuario

CHECK WEIGHING (DEFAULT)

Make sure that the check mode is set to check
weighing in the configuration menu
Place objects on the pan. The Under/Accept/Over status
is shown in the progress bar area while the actual
weight of the item is shown on the main display line.
THE CHECK WEIGHING HOME SCREEN
NOTE: Press the
explanation.
Defining Over/Under Limits and Tolerance
1. Press the button corresponding to the
enter Limit Setup. (See Figure 23)
Figure 23
2. Select Over or Under Limit and press the button
corresponding to the
3. Enter the desired value for the limit using the
alphanumeric keypad. Then press the button
corresponding to the icon
and go back to previous screen.
Alternatively, the limits can be set by Target Weight
Tolerance. To set the tolerance, press the button
corresponding to the
setup. (See Figure 24)
PAGE 11 OF 105
OPERATION CONTINUED
.
Main Display Line
Reference Fields
Functions
button for button icon
i
icon to
icon to edit the value.
to set the value
icon to enter the Tolerance
Figure 24
To switch between Over/Under Load, Target Weight
Tolerance, Target Weight Percentage, press the button
corresponding to the
value by using the alphanumeric keypad and press
the button corresponding to the
changes and return to previous screen. (See Figure 25)
Figure 25
NOTE: The three set limits methods share the
same data.

CHECK COUNTING

Press the configuration button
Mode to Check Counting. Place objects on the pan.
The Under/Accept/Over status is shown in the progress
bar area while the actual number of pieces is shown
on the main display line.
THE CHECK COUNTING HOME SCREEN
NOTE: Press the
explanation.
icon. If desired, edit the
icon to save the
and select Check
Main Display Line
Reference Fields
Functions
button for button icon
i
0721 IH-7991