Filling The Tank; Operation; A - Checks Before Use - Ghibli S4 EXPLORER Uso Y Mantenimiento

8.1 - FILLING THE TANK

(Fig. 19)
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Extract the supplied tube (1) and connect
its end (1a) to a tap, leaving the other end
in the tank.
- Turn on the tap and fill the tank (2).
- Pour liquid detergent into the tank or, in
the case of the optional metering system,
check the level of detergent in the deter-
gent tray.
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
- In the event of eye or skin contact with
the detergent, or ingestion of the de-
tergent, see the detergent manufac-
turer's usage and safety data sheet.
- After having filled the tank, insert the end
(1a) into the tank's opening.

9.1 - OPERATION

9.1.a - Checks before use

- Check that the recovery tank's drain-
age tube (1) is properly connected and
sealed.
- Check that the squeegee's water suction-
ing tube (2) is properly inserted into the
recovery tank.
- Check that the coupling (3) on the squee-
gee (4) is not obstructed and that the tube
is properly connected.
- Make sure that the tap (5) is open.
- Check the charge status of the batteries
by turning the key (6) to its "ON" position
and checking the charge indication on the
display (7).
(Fig. 20)
EN - 21
7
1
5
3
4
EN
1a
1
2
Fig. 19
6
2
Fig. 20