Samsung SCC-C6323N Manual Del Usuario página 22

Operation
PRESET
• Function
Max. 127 positions can be stored as Preset position.
The Preset number can be assigned from 1 to 128. It
is noted that preset "95" is reserved for starting OSD
menu.
Camera characteristics (i.e. White Balance, Auto
Exposure) can be set up independently for each
preset and they are adjusted by using OSD menu.
Four relay outputs can be controlled in conjunction
with one Preset.
• Set Preset
<Set Preset> [1~128]
• Run Preset
<Go Preset> [1~128]
• Delete Preset
To delete Preset, use OSD menu.
AUTO PAN
• Function
By using Auto Pan function, you can make camera
to move between 2 Preset positions repeatedly.
When Auto Pan function runs, camera moves
from the preset assigned as the 1st point to the
preset assigned as the 2nd point in CW(Clockwise)
direction. Then camera moves from the preset
assigned as the 2nd point to the preset assigned as
the 1st point in CCW(Counterclockwise) direction.
1st Preset
In case that the preset assigned as the 1st point
is same as the preset assigned as the 2nd point,
camera turns on its axis by 360˚ in CW(Clockwise)
direction and then it turns on its axis by 360˚ in
CCW(Counterclockwise) direction.
Speed can be set up from 1˚/sec to 180˚/sec.
• Set Auto Pan
To set Auto Pan, use OSD menu.
22 – 10X MINI SMART DOME CAMERA
• Run Auto Pan
Method1) <Run Auto Pan> [Auto Pan NO.] [Enter]
Method2) <Go Preset> [Auto Pan NO.+140]
ex) Run Auto Pan 2 : <Go Preset> [142]]
• Delete Auto Pan
To delete Auto Pan, use OSD menu.
PATTERN
• Function
Pattern Function enables to memorize the path (mostly
curve path) created by keyboard controller. By running
the pattern, the memorized path can be reconstructed
exactly as it memorized whenever required.
4 Patterns are available and Maximum 1200
communication commands can be stored in a pattern.
• Set Pattern
Pattern can be created by one of following two
methods.
Method 1) <Set Pattern> [Pattern NO.]
2nd Preset
Method 2) OSD Using OSD Menu:
See the section "How to use OSD Menu".
– Pattern editing screen is displayed as bellow.
EDIT PATTERN 1
[NEAR:SAVE / FAR:DELETE]
– Movement by Joystick and preset movement
can be memorized in a pattern.
– The rest memory size is displayed in progress
bar.
– To save the recording, press NEAR key and to
cancel, press FAR key.
0/0/X1/N