Setting Calibration Interval - Bahco TAWM Serie Traducción De Las Instrucciones Originales

1. From Configure menu, use UP/DOWN buttons to highlight SET DATE/TIME selection then press
ENTER button.
2. SET DATE screen is displayed with year highlighted.
3. Use UP/DOWN buttons to set year then press ENTER button to highlight month.
4. Use UP/DOWN buttons to set month then press ENTER button to highlight day.
5. Use UP/DOWN buttons to set day then press ENTER button.
6. SET TIME screen is displayed with hour highlighted.
7. Use UP/DOWN buttons to set hour then press ENTER button to highlight minutes.
8. Use UP/DOWN buttons to set minutes then press ENTER button to highlight seconds.
9. Use UP/DOWN buttons to set seconds then press ENTER button.
10. Clock is set and Configure menu is displayed.
STD
SLIM
Note: Year selection will scroll up from 2018. Month selection will scroll from 1 to 12. Day selection will
scroll from 1 to 31.
Note: Hour selection will scroll through 0 to 23. Minute and Second selections will scroll through 0 to 59.
Note: If batteries are removed from wrench for longer than 20 minutes, clock will revert to default set-
tings and must be re-entered at power on.

SETTING CALIBRATION INTERVAL

This function will allow user to set calibration interval for when "CAL NEEDED" message will be displayed.
1. From Configure menu, use UP/DOWN buttons to highlight SET CAL INTRVAL selection then press
ENTER button.
33