About This Product; Product Description - Bosch rexroth 3842 559 921 Manual De Instrucciones

5

About this product

5.1

Product description

The basic function is the retraction and extension of the lifting modules
• Power supply unit and synchronous control for lifting modules
• Operation of the lifting modules (retraction and extension) using the
connected hand switch
• Clamping protection due to safety stop; 25 mm before the retracted end
position and further movement at reduced speed
• Height indication [cm/inch]
• Collision protection (optional)
• Synchronization of up to four controls possible by means of optional
distributions
• The control unit will switch off in case of excessive heating
Overload protection
To prevent damage to the lifting module, the control unit identifies
an excessive loading of the lifting modules by means of the power
consumption and switches them off.
The overload protection must not be used and load limitation
in everyday use!
Safety area
During retraction, the control unit will stop 25 mm before the end
position (finger protection). The user must release the button and press
it once again to move to the end position at reduced speed.
Duty cycle
10% = 2 min ON, 18 min OFF.
The control unit monitors the real power consumption and stops the
lifting modules, if necessary, to protect them from overload. With partial
load, the duty cycle is extended.
3 842 559 935/2019-08, MPS: Control unit, Bosch Rexroth AG
About this product 13/30