Packaging; Chapter 4. Limits And Conditions In The Use Of Machine; Max. Pack Sizes; Items Which Must Not Be Packed - Minipack-Torre FM76A Digit Instrucciones Para La Instalación, Uso Y Mantenimento

Ocultar thumbs Ver también para FM76A Digit:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
Chapter 3. Machine adjustment and setting up

3.11. Packaging

Press the start button (7). The transparent hood (19) will be lowered automatically for cutting, sealing, and if selected
shrink-wrapping of the pack (figure 3.11.A page 68).
When the hood opens again, the pack will be moved to the roller conveyor (26), so that the sealing area will be free for
another cycle (figure 3.11.B page 68).
If the machine is in an automatic cycle-position, it will start a new packaging cycle at the end of the set time pause.

Chapter 4. Limits and conditions in the use of machine

4.1. Max. pack sizes

a = mm 500
b = mm 380
N.B.: measurements shown refer to the maximum for the single dimension.
Refer to chapter 5.2. to get max. dimension of pack (b x c); the addition of (b + c) is equal to film roll width minus 100
mm.

4.2. Items which must not be packed

The products listed below must absolutely not be wrapped to avoid permanent damage to the machine and serious
injuries to the operator:
Wet and unstable products
Liquids of any kind and density in fragile containers
Flammable and explosive materials
Pressurised gas cylinder of any kind
Loose and volatile powders
Loose materials with grain size smaller than the holes of the conveyor belt
Any materials and products not listed but which might harm operator and damage the machine.

Chapter 5. Film features

5.1. Films to be used

The machine can work with all heat-shrink and non-heat-shrink films, from 15 to 50 microns in thickness, of a technical
and food type. To guarantee the best results, use the films marketed by us.
The special features of our films (which may be customised with drawings and text) assure their outstanding reliability,
with regard both to compliance with laws in force and to excellent machine performance.
Consult the data and safety sheets of the films in use and observe the corresponding instructions!
A = mm600 MAX

5.2. Band A calculation

Band A = b + c + 100mm (figure 5.2. page 68).

Chapter 6. Safety standards

6.1. Warnings

THE MACHINE CAN NOT BE USED BY UNTRAINED PERSONNEL!
During work pay attention to all hot parts of the machine. The temperature they can reach is so high
that it can cause burns.
Smoking is forbidden while the machine is operating!
c = mm 250 (figure 4.1 page 68).
D = mm250 MAX
d = mm77 (figure 5.1 page 68).
15
GB
GB
GB
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido