Chicco Go-One Isofix Manual Del Usuario página 35

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
R. Pocket for storing the instructions booklet
S. Guide for inserting the lap section of the
3-point car safety belt
S1. Guide for inserting the diagonal section of the
3-point car safety belt
T. Clamp for fastening the diagonal section of
the car safety belt
U. Installation instructions labels
V. ISOFIX System
Diag. 4 (ISOFIX System Detail)
W. Connectors
X. Protective caps
Y. Release buttons
Z. Locking indicators
Diag. 5 (TOP TETHER Detail)
AA. Belt
BB. Adjuster
CC. Tension indication
DD. Hook
RESTRICTIONS AND REQUISITES REGAR-
DING THE USE OF THE PRODUCT AND CAR
SEAT
CAUTION! Read these use restrictions and requi-
sites carefully to ensure the product is used safely.
up to 18 Kg of weight.
the car safety belt, the car seat must be equip-
ped with a 3-point static or 3-point retractor sa-
fety belt, approved to UN/ECE No. 16 regulation
or other equivalent standards (diag 6).
WARNING! In case of use in vehicles equipped
with rear seat belts with integrated airbags (infla-
table belts), the interaction of the inflatable por-
tion of the vehicle's belt with this child restraint
can result in serious injury or death!  Do not in-
stall this child restraint using an inflatable seat
belt. Install using ISOFIX instead, or move the car
seat to a position with a suitable seat belt type. 
When installing with ISOFIX, the unused seat belt
should not be buckled behind the Child Restraint
System as this will engage the inflatable portion
of the belt.
FIX system in the positions indicated in the
instructions for use of the vehicle.
passenger seat or any other back seats, always
in a forward facing direction. Never use this
child car seat fitted into car seats facing side-
ways or facing rearwards (diag. 7).
WARNING! According to car accident statistics,
the rear seats of a car are generally safer than
the front seat: it is therefore recommended to fit
the child car seat into the rear seats of the car. In
particular, the central rear seat is the safest. If the
child car seat is fitted in the front seat of the car,
in order to ensure maximum safety, it is recom-
mended to push the seat back as much as possi-
ble, bearing in mind the comfort of the passenger
sitting in the seat directly behind it and adjusting
the backrest to the most vertical position. If the
car is equipped with a safety belt height adjuster,
fix it in the lowest position, then check that the
car seat safety belt adjuster is either in a backward
position with respect to the backrest of the car
seat (or at least aligned to it).
It is not recommended to fit the child car seat into
a front seat equipped with airbag. If you wish to fit
the child car seat in any seat protected by airbag,
always refer to the vehicle instructions manual.
WARNING! Never fit the child car seat to a seat
that is only equipped with a horizontal 2-point
safety belt (diag. 8).
Make sure that the buckle seat belt is not too high
(Diag 31). Otherwise, try to install the car seat for
your child on another car seat in the car.
FITTING THE CHILD CAR SEAT INTO THE CAR
WITH THE ISOFIX SYSTEM
PREPARING THE INSTALLATION
1. Pull the unlocking handle of the ISOFIX system
externally (diag. 9).
2. While keeping the handle pulled, pull out the
ISOFIX system COMPLETELY from the rear of
the backrest (diag. 10). Ensure that the system
has been pulled out completely.
3. Push the two red buttons (Y) of the ISOFIX
connectors inside (diag. 11a) and, while ke-
eping them pressed down, remove the two
protective caps (X) (diag. 11b).
4. Place the two caps into the appropriate hou-
sings, located under the base (diagrams 12a -
12b).
WARNING! Store the caps in a safe place, since
they are indispensable for reinserting the ISOFIX
system inside the base when the system is not
in use.
HOW TO FIT THE CHILD CAR SEAT
-
5. Place the child car seat on the selected seat.
WARNING! Check that there are no loose
objects between the child car seat and the
car seat or between the child car seat and the
door of the car.
6. Insert the two ISOFIX connectors into the cor-
responding ISOFIX locking devices, located on
the car seat, between the backrest and the
seat (diag. 13). WARNING! Ensure that the two
35

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Go-one

Tabla de contenido