Cleaning The Appliance; End Of Use; Troubleshooting - Imetec F4101 Instrucciones Para El Uso

Cleaning the appliance

Before cleaning the appliance, switch it off by pressing the ON-OFF button (12) and
disconnect the plug (13) from the socket. When necessary, clean the appliance with a
damp cloth. Do not use solvents or other aggressive or abrasive detergents. Otherwise, the
surface could be damaged. Make sure all cleaned parts are completely dry before reusing
the appliance.
Switch the appliance off by pressing the ON/OFF button (12).
• Disconnect the plug (13) from the socket.
• Wait for the appliance to cool down completely before putting it away. The reservoir
does not have to be emptied.
NOTE:
If the appliance is not to be used for several weeks, empty the water reservoir
(2) completely, wait for the appliance to cool down completely and turn it over to
allow all the water to flow out of the reservoir (2).
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The appliance does not turn on.
The plate temperature LED (17)
goes on and off.
Smoke comes out of the
appliance when it is switched on
for the first time.
Impurities come out of the plate
(14) of the new iron.
Drops of water come out of the
plate (14).
The appliance does not produce
steam.

END OF USE

TROUBLESHOOTING

Possible cause
The household appliance is not on.
Normal procedure.
This is absolutely normal and is
due to the expansion of the plastic
material.
This is perfectly normal in a new
iron.
The iron temperature adjustment
knob (16) is set to a temperature
that is too low for steam ironing.
The appliance is not on.
The steam button (15) is not being
pressed.
The water in the reservoir (2) has
finished and the no water LED (7)
is on.
Solution
Ensure that the appliance is properly
connected to the socket, that the ON/
OFF button (12) is pressed and the light
is on.
The switching ON and OFF of the LED
(17) indicates the heating phase of the
iron. The LED goes off once the set
temperature is reached.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used
a few times.
Adjust the temperature for steam ironing
(see the "IRONING" chapter).
Press the ON/OFF button (12).
Keep the steam button (15) pressed as
you iron.
Fill the water reservoir (2) (see chapter:
Filling the reservoir while ironing).
EN
15