Spark Plug - Homelite HBP-30 Manual De Utilización

Soplador térmico de mochila
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
GB
F
D
E
I
MAINTENANCE
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately. Failure to do so could result
in a fire that could cause serious personal injury.
The fuel cap contains a non-serviceable filter and a
check valve. A clogged fuel filter will cause poor engine
performance. If performance improves when the fuel cap
is loosened, the check valve may be faulty or filter
clogged. Replace the fuel cap if required.

SPARK PLUG

This engine uses a Champion RCJ-6Y with 0.63 mm
(0.025 in.) electrode gap. Use an exact replacement and
replace annually.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine starts but will only run
at high speed at half choke.
Engine does not reach full
speed and emits excessive
smoke.
Engine starts, runs, and
accelerates, but will not idle.
P
NL
S
DK
N
FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Starter rope pulls harder now
than when new.
Carburetor requires adjustment.
Carburetor requires adjustment.
1. Oil / fuel mixture is incorrect.
2. Air filter is dirty.
3. Spark arrestor screen is dirty.
4. Carburetor requires
adjustment.
Idle speed adjustment screw on
carburetor needs adjustment.
CZ RU
RO PL SLO HR TR EST LT
English
WARNING
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.
STORAGE (1 MONTH OR LONGER)
Drain all fuel from the tank into a container approved
for gasoline. Run engine until it stops.
Clean all foreign material from the blower. Store it in a
well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all Federal and local regulations for the safe
storage and handling of petrol. Excess fuel should be
used up in other 2-stroke engine powered equipment.
1. Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch
for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until fuel is visible in the
bulb. If fuel is not apparent, the primary fuel
delivery system is blocked. Contact a
servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Contact a servicing dealer.
Contact a servicing dealer for carburetor
adjustment.
Contact a servicing dealer for carburetor
adjustment.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter, refer to "Replacing and
Cleaning the Air Filter" earlier in this manual.
3. Contact a servicing dealer.
4. Contact a servicing dealer for carburetor
adjustment.
Turn idle speed adjustment screw (31) clockwise
to increase idle speed (Fig. 9).
15
LV
SOLUTION
SK BG

Publicidad

Tabla de contenido
loading

Tabla de contenido