Output Control - Miller Syncrowave 250 DX Manual Del Propietário

4-5. Output Control

2
1
Current (A)
Initial Amps
Preflow
Push & Hold
Foot Or Finger
Remote Control
1 Output Control
Y Weld output terminals are ener-
gized when power is On, and Out-
put On LED is lit.
Use control to select front panel, trigger
hold, or remote output control.
NOTE: Lit LED indicates selected mode.
For weld output, press button to toggle LED
to On position.
OM-363 Page 28
Remote (Standard)Torch Trigger Operation
Remote (Standard)Torch Trigger Operation
Weld Amps
2 Remote Trigger (Standard) Operation
For remote output control, press button to
toggle LED to Remote position (see Sec-
tion 3-7).
Torch trigger operation is as shown.
NOTE: Initial weld amperage and final am-
perage is controlled by the remote device,
not by the welding power source.
(CE Nameplate)
2
Final Slope
Final Amps
Release Foot Or
Release For
Finger Remote
Maintained Switch
Control
NOTE: If On/Off only type trigger is used,
it must be a maintained switch. All func-
tions become active.
Application: Use Remote Trigger when
the operator desires to use a foot pedal or
finger amperage control.
When Output Selector switch (see Section
4-2) position changes, Output control LED
will always switch to Remote.
1
Postflow