Section 3 − Installation; Selecting A Location - Miller Syncrowave 250 DX Manual Del Propietário

3-1. Selecting A Location

Movement
1
OR
Location And Airflow
1
18 in (460 mm)
Y Falling Unit Can Cause Injury.
S
Use lifting eye to lift unit only, NOT
running gear, gas cylinders, or any
other accessories.
S
Use equipment of adequate capacity
to lift and support unit.
S
If using lift forks to move unit, be sure
forks are long enough to extend
beyond opposite side of unit.
SECTION 3 − INSTALLATION
250 DX Models
5
SERIAL NO.
STOCK NO.
PROTECTED B Y ONE OR MORE OF THE
FOLLOWING US. PATENTS:
XXXXX05
XXXXX10
XXXXX24
XXXXX42
EVIDENCE OF LABEL T AMPERING VOIDS WARRANTY
18 in
(460 mm)
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Serial Number/Patent Label
4 Rating Label
Use rating label to determine input power
needs.
2
3
LR5071
XXXXXXX3
® ®
XXXXXXXXXXXXXX4
C US
XXXXX06 XXXXX07 XXXXX09
XXXXX11 XXXXX15 XXXXX21
XXXXX25 XXXXX26 XXXXX32
XXXXX47 XXXXX48
4
5 Line Disconnect Device
Locate unit near correct input power supply.
Y Special installation may be required
where gasoline or volatile liquids
are present − see NEC Article 511 or
CEC Section 20.
Y Be careful when placing or moving
unit over uneven surfaces.
Ref. 117 264-C / 803 584-B / 216 202-D / 216 203-C / 208 998
350 LX Models
3
LR5071
SERIAL NO. XXXXXXX3
® ®
STOCK NO. XXXXXXXXXXXXXX4
C US
PROTECTED B Y ONE OR MORE OF THE
FOLLOWING US. PATENTS:
XXXXX05 XXXXX06 XXXXX07 XXXXX09
XXXXX10 XXXXX11 XXXXX15 XXXXX21
XXXXX24 XXXXX25 XXXXX26 XXXXX32
XXXXX42 XXXXX47 XXXXX48
EVIDENCE OF LABEL T AMPERING VOIDS WARRANTY
4
OM-363 Page 7