Functional Description; Risk Of Fire - Abicor Binzel FES-200 W3 Instrucciones De Servicio

5 Functional Description

4.1 Transport
The scope of delivery is carefully checked and packaged, however damage may occur during shipping.
Make sure that the shipment is complete by referring to the delivery note!
Checking procedure
on receipt of goods Check the delivery for damage (visual inspection)!
If the delivery has been damaged during transport, contact the last carrier immediately! Keep the
In case of complaints
packaging for possible checks by the carrier.
Use the original packaging and the original packaging material. If you have questions concerning the
Packaging for return
shipment
packaging and safety during shipment, please consult your supplier, carrier or transporter.
Transport
Tab. 6
4.2 Storage
For ambient conditions for storage in a closed environment, see:
Tab. 3 Ambient conditions for transport and storage on page EN-4
5 Functional Description

Risk of fire

Before installing and operating the fume extraction system, please observe the following:
• The extraction of welding fume during welding of oil-wetted parts is not allowed.
• It is not allowed to install or operate the system in areas subject to dust or gas explosion hazards.
• Before putting into operation, it must be checked if the operating voltage given on the nameplate
NOTICE
• Use the fume extraction system FES-200 W3 only in areas with sufficient ventilation.
• The fume extraction system is equipped with a safety device to monitor the minimum air volume flow to
EN - 8
DANGER
CAUTION
corresponds to the mains voltage.
be extracted. A manometer is used for monitoring. The point at which the minimum volume flow is
reached is marked on the dial scale. If the manometer indicates a higher vacuum (>180mbar), the
filter must be cleaned.
FES-200 W3