Risk Of Burns - Abicor Binzel PP Serie Manual De Instrucciones

4 Putting into operation
4.3 Connecting the PP control lead
Potentiometer
+
Trigger
_
_
Motor
+
Fig. 4 Connecting the control lead
EN - 8
WARNING

Risk of burns

The welding torches will become overheated if the coolant level is too low.
• Wear protective gloves.
• Check the coolant level at regular intervals.
NOTE
• Check the minimum coolant level of the cooling unit.
• Coolant supply = blue, coolant return = red.
• Make sure that liquid-cooled PP welding torches are only operated with
the ABICOR BINZEL coolant BTC-15.
• Each time the device is commissioned or after each cable assembly
change, the cooling system must be purged of any air. Disconnect the
coolant return hose from the re-circulating cooling unit and hold it over a
collecting device. Close opening at the coolant return. Open it again by
repeatedly and abruptly releasing it, until the coolant is flowing
continuously and without air bubbles.
Torch side
5
BR BR
4
WS WS
3
GR GR
BR BR
GN GN
WS WS
GE GE
The control lead is open on the machine side. The customer has to provide the
connection of a suitable plug. If all data are provided, the machine can also
be delivered ready-to-connect. Otherwise choose a compatible plug for your
power supply and solder it to the corresponding leads according to the
connection diagram.
Machine side
BR
WS
GR
BR BR BR
Central plug
GN WS WS
WS WS WS
GN GE GN
PP